Conversations about electronics, hardware, and the engineering life. Hosted by Parker Dillmann and Stephen Kraig.
Stephen debarks into the cold void that is linux. Will he survive the frozen sudo tundra? Adventures in Rapsberry Pis and Wiring Hardness designs!
Parker's pinball controller has gone gold! Revision 3 is being fabricated! Stephen then explores the softness factor of diodes and the SSPS returns?
Revitalizing older products for next gen manufacturing can be tough. Does updating the design alter the spirit of the original? Oh and Tariffs.
There is a new regulatory stamp in town now. Brexit has spurred the formation of the UKCA mark to replace the CE mark in the Queen's land.
Will graphene allow us to transcend to the next level of existence with free energy? Parker and Stephen discuss limitless power and the iPhone 12.
Stephen finally gets a license for the Eagle EDA Tool but not for the reasons you would expect! Also, sheet metal design and IoT device security!
Chris Carter joins Parker and Stephen to discuss Design for Manufacturing for PCB Assemblies. Part one of a series of podcasts!
Stephen deeps dives into schematics and connectors this week by asking what is the best way to draw symbols for connectors on schematics? Net Names!
How do you know if an electrical component is inexpensive? When it says "Cost Effective" as a main bullet point on the datasheet!
Do you get a warm, fuzzy feeling inside you when you find that exact electrical part you are looking for? If so, come listen to this podcast!
Need to find a transformer for your product design? Stephen goes through the process of getting a custom transformer manufactured for a new product!
Hyr0n and Zapp are back! This time to discuss Firmware Stacks, Real Time Operating Systems, and more #Badgelife shenanigans.